The PC does not recognize one of the modules (puriFlash)
![Post Post](https://www.interchim.com/forum/styles/prosilver/imageset/icon_post_target.gif)
The PC does not recognize one of the modules, what should I do?
Concerned instruments: puriFlash 215, puriFlash 430, puriFlash 450, puriFlash 4100, puriFlash 4250
Concerned module: control unit
There are several possible causes:
- Incorrect connections
- Defective power cords
- Defective RS232 cable
First, check the cables, then the communication ports.
Ensure that each individual module is turned on.
If the problem persists, replace the cable.
Concerned instruments: puriFlash 215, puriFlash 430, puriFlash 450, puriFlash 4100, puriFlash 4250
Concerned module: control unit
There are several possible causes:
- Incorrect connections
- Defective power cords
- Defective RS232 cable
First, check the cables, then the communication ports.
Ensure that each individual module is turned on.
If the problem persists, replace the cable.