|
Gene-PAGE - Code X309, X388, K117 or J228 Directions for use |
| For best results, this product should be allowed to warm to room temperature before use. |
| Note:
On occasion, the
Urea used as a denaturant in Gene-PAGE may begin to re-crystallize when
stored at the recommended 4°C. This will not affect product performance,
as long as the Urea is returned to solution before use. Simply place the
product in a 37°C water bath for ten minutes, swirl the product briefly
to re-mix, and use as directed below.
1- Determine the total volume of the gel plates you are using. Aliquot the required amount of Gene-PAGE into a sidearm flask. Note: It is usually helpful to allow an additional 10 ml to accommodate any possible leaks in the apparatus.). Degas under gentle vacuum for five to ten minutes at room temperature. 2- Add Ammonium Persulfate (code 0486) from a 10% stock solution freshly prepared in deionized water at a ratio of 100 µL for each 10 ml of Gene-PAGE, and TEMED (code 0761) at a ratio of 10 L for each 10 ml Gene-PAGE. If slower polymerization is desired, 60 µL of 10% ammonium persulfate solution and 6 µL of TEMED may be used, respectively. Mix the solutions by swirling gently, and immediately pour into a prepared glass plate assembly. Insert an appropriately sized comb into assembly and allow gel to polymerize completely (30-45 minutes in most cases). Gene-PAGE is intended for use with 1X TBE buffer. TBE is available from AMRESCO in a 10X liquid concentrate (code 0658) and a 10X Ready-Pack( (code 0478). |
|
Also Available from AMRESCO: |
|
|
|
Montluçon 211 Bis Avenue Kennedy BP 1140 03103 Montluçon cedex - France tel (33) (0) 4 70 03 88 55 fax(33)(0) 4 70 03 82 60 http://www.interchim.com |
Vos contacts: Etienne Boireau - Olivier Cadas - Olivier Alméras hot line 33 (0) 4 70 03 73 06 |
|